Does anyone have any pictures or diagrams for a stripped down install for a race car? I'm planning on sealing up everything I can on the intake manifold and I'd love to see what someone else has done.

thanks,
-Trent
www.rxracing.com

 

Anyone, Beuller? Beuller?
I'm looking for throttle plate linkages and vaccum ports to seal up. Basically the mechanical side of getting the intake system ready to go.

-Trent

 

well for mine i got the k2rd block off kit which basically blocks everthing off. then after that i put a vacum cap on every nipple except the one on the oil fill tube, i left that one open to atmoshpere since i ditched the charcol canister. on the fornt of the throotle body, the lower most nipple is the best source of vacum boost that i know of so my ecu and fpr are run off that. the uppper most one on the fornt is going to my bov. on the back the one to the brake boost is still factory, the top nipple is going to the secondary air bleeds, the 3rd one down is going to the primary air bleeds, the nipple on the inside on the lwer intake manifold is going to the wastegate, and finally the one on bottom of the upper intake pointing to the cruise control is going to the avcr. if you want pics then left me know.

 

Just search for emissions removal in whatever generation forum car you're thinking about doing this on.

That typically gets plenty of results as far as vacuum line diagrams go.

 

Thanks,

-Trent