Microtech sT all the time?
Thread Starter
Joined: Mar 2001
Posts: 5,268
Likes: 147
From: Floyds Knobs. IN
sT all the time?
Next issue. Setting up the idle is proving to be trying at best. The adjustments seem to be very course. It's either too rich or too lean. Then I notice the display is showing sT (staged injectors active) at all times. It should read mS below the switch on points correct? The settings are 3000rpm and 0psi. At idle I can crank the staged percentage up and down and change the a/f ratio. This tells me I'm running all four injectors at the same time and it sounds like an ECU problem. Thoughts? Help! 
Thread Starter
Joined: Mar 2001
Posts: 5,268
Likes: 147
From: Floyds Knobs. IN
Found the answer to my question on the Microtech forums. The manual, the way I read it, is *** backwards. Back to the drawing board! Excellent thread on stage setup here.
http://microtechefi.com/forum/viewto...ghlight=staged
http://microtechefi.com/forum/viewto...ghlight=staged
Last edited by C. Ludwig; Jul 20, 2006 at 09:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
Engine Management Forum
11
Nov 9, 2015 01:15 PM