sT all the time?
 

Next issue. Setting up the idle is proving to be trying at best. The adjustments seem to be very course. It's either too rich or too lean. Then I notice the display is showing sT (staged injectors active) at all times. It should read mS below the switch on points correct? The settings are 3000rpm and 0psi. At idle I can crank the staged percentage up and down and change the a/f ratio. This tells me I'm running all four injectors at the same time and it sounds like an ECU problem. Thoughts? Help! :D

Found the answer to my question on the Microtech forums. The manual, the way I read it, is ass backwards. Back to the drawing board! Excellent thread on stage setup here.

http://microtechefi.com/forum/viewto...ghlight=staged