Microtech RPM error and REF error
#1
RPM error and REF error
Hi all,
I started my car this morning to find that I have a REF error and RPM error. The car runs fine but it's scaring me. I've tried to stay out of boost as much as possible.
Can someone please give me some tips on how to resolve these errors?
Thanks,
Jaime
I started my car this morning to find that I have a REF error and RPM error. The car runs fine but it's scaring me. I've tried to stay out of boost as much as possible.
Can someone please give me some tips on how to resolve these errors?
Thanks,
Jaime
#3
Moderator
iTrader: (1)
I was getting these same errors too when I found my CAS' wiring (where It just starts to come out from the CAS Itself) Insulation was cracked causing the exposed wiring rub against each other.
You'd be surprised to see how many FC owners have this same problem due to the broken Insulation from the CAS. Have a looksy.
You'd be surprised to see how many FC owners have this same problem due to the broken Insulation from the CAS. Have a looksy.
#5
Rotary Freak
iTrader: (8)
I was getting these same errors too when I found my CAS' wiring (where It just starts to come out from the CAS Itself) Insulation was cracked causing the exposed wiring rub against each other.
You'd be surprised to see how many FC owners have this same problem due to the broken Insulation from the CAS. Have a looksy.
You'd be surprised to see how many FC owners have this same problem due to the broken Insulation from the CAS. Have a looksy.
But sometimes it can be random.
I like to suggest to see how consistent the error is before ripping wiring apart.
But the above would be the first place to check if the error is coming up often.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM