littlered2

Ok i have this on my fc(on it when i bought it). i need to set a rev limiter and i would like a 2step also. I am also having a small idle issue. sometimes the car idles fine and after running for a while it will bounch and die from time to time. also im noticing a little bit of "break up" at WOT randomly. any ideas?
im also in ohio near cincy if anyone is close that knows microtec.

i also have the handset for the ecu if that matters much

littlered2

on the handset i scrolled to rpm/lim and set it to 6500 and rev up and nothing. am i missing something?

flaco

iTrader: (7)

you might need a tune . what afrs you have ?

littlered2

i know the tune needs touched up a bit. idle im about 12.5-13 wot im about 10.5-11.5 on the highway about 13-13.5

Aaron Cake

iTrader: (1)

Before you set 2 steps and rev limiters, fix that tune. Yikes, that thing is rich. Once you have the tune refined, then you can enable the fun features.

littlered2

how bad could it hurt the motor being that rich?

bumpstart

FFS.. did you miss the umpteen million warning all over the net to NOT use the REVlim function on a rotary

your ignorance,, your shrapnel/////


its also not working ( luckily for you ) cause you free revved the engine,,, which never staged the secondary injectors,, which therefore never cut out to effect REVlim

..... here it is ... in english..... from someone with vast experience with that ecu across many many vehicles ...............
DO NOT USE THE microtech REVLIM function on a rotary ............. it DOES cost engines

littlered2

i have a rev cut set so it cuts spark at 8500. i researched that much before i did anything