gergrx7

hey guys, i ordered my microtech from a group buy and it only came with the hand controler no cd or laptop adaptor. so i bought a laptop adator from someone on the forum. i have read the manuel over and over i know it says only certian computer will work with laptop and you much check for sticker on bottom of computer but i cant since mine is in body shop at the moment. I should be getting it back tommorow and i need to know if the program that is on the microtech website is the same as the disk?

gergrx7

oh yea what are most of you useing for a laptop? the laptop i have doesn't have a serial port so should i just get a serial - usb adaptor cable? or try to find a cheap older laptop with a serial port. i was told by a friend of mine who works on computer not to adapt serial-usb, but i an wondering what you all are doing for this.

Crusader_9x

The software that you find on the website should be the same software that comes on the cd. I went through a few different usb to serial adapters to find one that works. First off to get it to work your going to have to make sure that the usb to serial device is set to use com port one ot two. The on e i finally got that worked i got at bestbuy. I wanna say that it has a greenish theme to it and the company name is iogear? If you search this section then you'll find a thread or two addressing this issue that i used when i had that problem. By the way my laptop is a compaq presario model number 700 us.

FC_mania

hey greg , im veilside here... as i said in the PM , the base maps are already loaded in the hand units as told to me by the microtech people.

gergrx7

This the one you use crusader?

http://www.bestbuy.com/site/olspage....2&type=product

Jason i am wondering if our computers are setup to use a laptop rather than JUST a hand controller.

Crusader_9x

Yeah that looks like that one. It shouldnt matter, i dont think you can set it up to use just the laptop or hand controller.

PowerOverFC

The one I have (USB > Serial) doesnt work, I think its logitech or something like that. apparently its because it communicates to fast, and I cant find a speed setting.

Crusader_9x

Yeah i bought a a couple of generics ones that didnt work either. Then i read on here that a few people that had different adapters than me got theres to work so i just spent some money and tried a few. I tried adjusting the speed settings on the ones i had that didnt work and it made almost no difference whatsoever.

Your going to have to go into device mnager and find the driver for your adapter then go into its properties to adjust the speed and other settings.

LT8TurboII

iTrader: (2)

I am using the IOGear adapter and it works fine.

PowerOverFC

ive been told its there but I guess this driver doesnt have that option... oh well, Im just going to guy a MT dedicated laptop anyway with a serial port.