Microtech Flooding out after a Walbro upgrade
#1
Rotary Freak
Thread Starter
iTrader: (3)
Join Date: Feb 2002
Location: MN
Posts: 1,697
Likes: 0
Received 0 Likes
on
0 Posts
Flooding out after a Walbro upgrade
Hey,
I had the car running for about 1000 miles (engine break-in period) on a stock TII fuel system, then, I upgraded the fuel pump to a Walbro and the secondary injectors to 720s. The MT still has a basic map on it, although it has been toyed with a bit by a tuner friend of mine. The tuning was done on the old fuel system.
I cant start the car with the new fuel system componenets. The car is behaving exactly as a flooded engine does. I crank it over, and the thing floods right up, and wets the plugs.
What do I need to change to get this thing to fire up?
-a
I had the car running for about 1000 miles (engine break-in period) on a stock TII fuel system, then, I upgraded the fuel pump to a Walbro and the secondary injectors to 720s. The MT still has a basic map on it, although it has been toyed with a bit by a tuner friend of mine. The tuning was done on the old fuel system.
I cant start the car with the new fuel system componenets. The car is behaving exactly as a flooded engine does. I crank it over, and the thing floods right up, and wets the plugs.
What do I need to change to get this thing to fire up?
-a
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM