Microtech differences
#3
Full Member
Join Date: Dec 2001
Location: deltona fl
Posts: 248
Likes: 0
Received 0 Likes
on
0 Posts
i have a lt8s with 4 bar map sensor.
one problem i just found out is that mine is a 4 bar map sensor which means that the software i need is for a 4bar map sensor when i was using the normal software not nowing that there was a upgraded software for higher boost control. has anyone had this problem ? i tuned my car as far as we could but i think that with the new software i will need to start all over again can anybody tell me?
#4
Rotary Enthusiast
Originally Posted by rx7theone
one problem i just found out is that mine is a 4 bar map sensor which means that the software i need is for a 4bar map sensor when i was using the normal software not nowing that there was a upgraded software for higher boost control. has anyone had this problem ? i tuned my car as far as we could but i think that with the new software i will need to start all over again can anybody tell me?
Dale
#5
Full Member
Join Date: Dec 2001
Location: deltona fl
Posts: 248
Likes: 0
Received 0 Likes
on
0 Posts
try the other vertion.
well you say you always use thet 45psi software so try the normal one and see what happens because on my ecu the boost would jump from 7psi to 12psi and from 17psi to 22psi all the way up tp 42psi on the load map which would not make any sence. try that and let me know if you see any diference thanks.roger.
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Spirit Rx-7
Suspension/Wheels/Tires/Brakes
6
03-14-16 12:36 PM
Captain Hook
2nd Generation Specific (1986-1992)
8
09-22-15 01:12 PM