Microtech Compatibility with FC3S in RX 8 Chassis
#1
Junior Member
Thread Starter
Join Date: Jul 2007
Location: Singapore
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Compatibility with FC3S in RX 8 Chassis
I'm doing a swap of FC in Rx8 but the the Microtech LT-10 can't read the power steering of the Rx 8 the setups are that LT-10 are to wiried to RX8 stock ECU and then to the FC but no readings from them.please advice
#2
Learned alot | Alot to go
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
Can you explain whats going on a little more? What does the RX8 have for sensory input and output on the powersteering? Is it just to raise the idle while turning? something else?
#3
Junior Member
Thread Starter
Join Date: Jul 2007
Location: Singapore
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
the problems i facing now is the power steering to the fc engine in my rx 8.the power steering is controlled electronically by a module and the microtech i'm using can't read the module.
#4
Senior Member
Join Date: Nov 2004
Location: Clearwater, Largo, St Pete Florida
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
#6
Senior Member
Join Date: Nov 2004
Location: Clearwater, Largo, St Pete Florida
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM