Microtech LTX12 (20B) on a 13b 4port
#1
FrankeRX7
Thread Starter
LTX12 (20B) on a 13b 4port
Hi
I have a Microtech LTX12 (programmed for a 20B) laying around, is it possible to use this on a old 13B 4-port.
Could I just use the outputs for the two rear rotors?
Fredrik
I have a Microtech LTX12 (programmed for a 20B) laying around, is it possible to use this on a old 13B 4-port.
Could I just use the outputs for the two rear rotors?
Fredrik
#2
I have wondered the same about other units
From my understanding I thought once the unit was configured for a specific application it had to go on that engine. You might have better luck posting this question on the MicroTechEFI Forum directly.
There seems to be more people responding to questions faster on that Forum.
There seems to be more people responding to questions faster on that Forum.
#3
On flats
iTrader: (29)
Join Date: Oct 2004
Location: Albuquerque
Posts: 1,379
Likes: 0
Received 0 Likes
on
0 Posts
no you can't. . .this is one of the primary reasons that I detest microtechs. You have to send it to microtech and have it reprogrammed. Expect major downtime and frustration.
Do yourself a favor and get a Haltech.
Do yourself a favor and get a Haltech.
#4
Rotary Freak
iTrader: (8)
Last time i dropped my microtech in for reprogram. Took 3 days and i had it in my hands.
Just dont send it to RXENG. This way it will take much longer, you will be going through a middleman before you actually get to microtech. Get it sent directly to microtech in putney NSW , australia and they will sort it out for you quick smart.
Just dont send it to RXENG. This way it will take much longer, you will be going through a middleman before you actually get to microtech. Get it sent directly to microtech in putney NSW , australia and they will sort it out for you quick smart.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
20B Forum
9
09-22-15 07:39 PM