I know i can run 2 injectors per channel, I was wondering does it mater witch ones i can run high or low independence 2 per channel?
Thank you

 

Some one has to know this..

 

I've been looking for the answer to this as well. The manual says the LT-8 can run either 4 low impedance or 8 high impedance, but I'm not sure if you can intermix them between channels. I emailed Microtech, but they wouldn't respond...

I'm wanting to run 2 primary injectors and 4 secondary injectors.

 

The microtech can run both high and low impedence injectors, however, you don't want to mix them. Either use all high or all low. You can run your two primaries as each channel and piggy back two each secondaries, but , I don't know if that will cause a problem later or not. If it were to, it would simply be an overload of power to the secondaries which may effect the LT-8 unit itself. If you got a unit to run 6 injectors, that would be ideal. I would pm rx72 to make sure about the reliability of running four injectors on two channels.