Megasquirt VE map for single turbo. Ms2 v3
Thread Starter
Senior Member
Joined: Oct 2008
Posts: 253
Likes: 0
From: round rock tx
VE map for single turbo. Ms2 v3
I am curious of anybody is willing to share a v e map for a single turbo Stockport na 13B
I am running.
Ms2 v3
Gsl-se engine with ported S5 intakes. 5/6 port actuators always open.
460 primary 1600 secondary
93 oct
BW s363
Water to air. IAT @ 45F on fresh ice. 100F max (pulls timing after 100F)
Target AFR. 13.7 <100kpa. 12.0 from 101kpa to 150kpa. 11.0 from 151 - 250kpa.
Runnin LS coils COP rx8/fd mode.
My logs and auto-tune suggestions keep adding a lot of fuel up in boost would just like to see what other people have done with a similar setup for comparison purposes
Thanks
I am running.
Ms2 v3
Gsl-se engine with ported S5 intakes. 5/6 port actuators always open.
460 primary 1600 secondary
93 oct
BW s363
Water to air. IAT @ 45F on fresh ice. 100F max (pulls timing after 100F)
Target AFR. 13.7 <100kpa. 12.0 from 101kpa to 150kpa. 11.0 from 151 - 250kpa.
Runnin LS coils COP rx8/fd mode.
My logs and auto-tune suggestions keep adding a lot of fuel up in boost would just like to see what other people have done with a similar setup for comparison purposes
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
haza88
Power FC Forum
2
May 17, 2019 04:42 PM
muythaibxr
Megasquirt Forum
0
Feb 3, 2009 08:05 PM
scrip7
Megasquirt Forum
4
Nov 25, 2007 08:13 PM
Curtisleeyoung
2nd Generation Specific (1986-1992)
13
Jul 8, 2005 01:05 PM