I've been going over the MS construction page for the v3.0 board and i have a question. Step 65 is the assembly of the high-current ignition driver circuit, however it shows instructions for the MS-II board and links to the MSnS-E page for further information if you're going that route.

On that page I cannot seem to find information on assembling the high-current ignition driver circuit for the Nippondenso dual wheel / 2nd trigger. Anyone have this info?

 

the two things are unrelated... the high-current ignition driver is not necessary for an rx7... you'll be making the mods I list in the FAQ instead...

What's needed for the dual-wheel/2nd trigger is the dual vr sensor conditioner... either a dual lm1815, or with the v3 board, use the built-in vr sensor conditioner for the 24 tooth wheel, and build a single lm1815 circuit for the 2nd trigger.

 

Right so you skip that section of the build then. Got it.

 

That's what I did!