I first 'squirted my GSL-SE back in 2001 using the v1.01 board. Worked great right up until I over-revved my engine one too many times and spun the rear bearing. Now that there's a new engine in the car I've loaded a slightly newer version of the code. MSnS was just being talked about way back when, and MSnS-Extra is what I've got on the car now.

I'm just getting my -SE back to near ready for the dyno. I've got it roughed in on the jack stands but if I can get someone to share a baseline 12x12 VE table with me, that could be a major time saver. Or, if someone can point me to a site/tool that will extrapolate a rough 12x12 table from a 8x8 table that would also save quite a bit of time. Even a rough extrapolation has GOT to be better than the default SBC VE table that's populating most of the table at the moment.

 

I think if you import a 8x8 vex file in MT it will interpolate the results to get a 12x12--that should be a big help.

On another related issue--does anyone know of a good ve table editing program? One that could change bins and leave your map the same, and maybe extrapolate bins if you want to go outside your current map. Sure would be handy.

Scott

 

mstweak3000 might do that... but I'm not positive on that.

 

Tim,

As Scott says, new releases of MT should allow importing of 8x8 and automatically generate 12x12 for you. Here's a web-based conversion tool from another MS user:

http://1800philes.com/megasquirt/

Roger.