not sure if this is a setting somewhere that has changed ,but pretty sure this problem has arisen when updating tunerstudio.

cant seem to change the kpa values in any of the tables above 150kpa on any of the y axis.can change the rpm values and they stick.my top 5 cells on y axis are 150 and when i go to enter a value higher it pops up error box saying value higher then 150 must be lower.

i have updated to latest tunerstudio.have also been doing some projects on ms1 and ms2 but this is a ms3x project that i hadnt previously had issue with.
cheers

 

also just tried using the generate ve map tool to try get axis changed.when generated will show new kpa values.then when go to apply generated ve table it wont apply the new values?
went and opened a ms1 table with the 12x12 table and was able to change values and they would stick.seems it has a issue with the 16x16 maps.

 

Your best bet for TS issues is to post on msextra.com.

Ken