smackhead999

iTrader: (5)

is anyone running something comparable to what ive got that could lend me a view at their setup to help me get started.

88 6port with t04 turbo
stock sensors
550 and 1600cc
missing tooth cas ms1 exta v3.o board

also what am i to put in for injector flow to get req fuel? ive searched and tried to find some equations for that and req fuel. i didnt know if it is the primary flow or an average or what.

thanks

Jobro

iTrader: (2)

Pretty sure you will be staging your primaries and secondaries

So Req fuel goes off primaries only, because only they work at idle.

Then you need to tell the software how and where to stage. And then also input the staging factor, which is primary/primary+secondary * 255, as it is just a raw value.

Don't take my post as gospel, wait for someone else to back me up, I've looked at the software, but have no experience at all on the fuel side of MS as yet. I'm planning on getting very closely acquainted with the fuel side in the university holidays. Come on 20-06-2007!

renns

Jobro's right on. It's all in the MS documentation. The req_fuel number is somewhat arbitrary, as it gets scaled by the VE table entries anyways. For base maps, try contacting terrh, as his setup is similar to yours in many ways.

smackhead999

iTrader: (5)

thanks... that is very helpfull

smackhead999

iTrader: (5)

and also, terrh if you would like to chime in with some input that would be cool too. all appreciated