hey, does anyone have the easytherm files hanging around for the stock IAT and CLT sensors that they wouldnt mind uploading? I built the MS1 V3 board with the recommended resistor for the IAT, i just dont have an ohm-meter capable of enough precision to get readings that i would trust for these sensors. Thanks!

 

When you open easytherm and click on "file" you will see "RX7 Defaults".
Just select it and thats all there is to it, as long as you built the MS with the proper mods to run the RX7.

 

oh, cool! didnt know that was there, i'll check it out tonight. Thanks!