Megasquirt resets then reads 1600rpm when crank
#1
i play with my wankel
Thread Starter
Join Date: Jul 2005
Location: North Manchester, Indiana
Posts: 1,630
Likes: 0
Received 0 Likes
on
0 Posts
resets then reads 1600rpm when crank
Have the Dave cap installed and a 33k resistor inline with the tach sig. Running MS-1 v 2.2 fuel only. When Im cranking MS resets and then after that the tach on MS read 1600 rpm and then after a few seconds the rpm goes back to 0. Any ideas? should i try a bigger resistor?
#2
i play with my wankel
Thread Starter
Join Date: Jul 2005
Location: North Manchester, Indiana
Posts: 1,630
Likes: 0
Received 0 Likes
on
0 Posts
nvm i found out it was resetting due to low voltage but it still didnt seem to have a tach sig. its late enough ill try again tom.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM