Megasquirt ms v2 w/3.57, contradicting info
#1
Learned alot | Alot to go
Thread Starter
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
ms v2 w/3.57, contradicting info
Long story short, a friend of mine dropped his s4 t2 off for me to wire up the megasquirt. 90% of this is strightforward, however im drawing a blank wiring the cas.
The diagram that came with the unit shows pin 2 and pin 24 for reluctor/distributor. im using a modified cas, is this the correct wiring then?
Where as this post shows the wiring using pin 7 and 24 respectivily where as pin 7 is a ground on my unit.
Another discrephency is that the linked post shows pin 8-11 and 15? as grounds (pin 15 should be pin 19?) where as my unit shows pins 7-9 and17-19 as grounds.
If anyone can point my in the right direction, it would be greatly appreciated.
thanks
-Jacob
The diagram that came with the unit shows pin 2 and pin 24 for reluctor/distributor. im using a modified cas, is this the correct wiring then?
Where as this post shows the wiring using pin 7 and 24 respectivily where as pin 7 is a ground on my unit.
Another discrephency is that the linked post shows pin 8-11 and 15? as grounds (pin 15 should be pin 19?) where as my unit shows pins 7-9 and17-19 as grounds.
If anyone can point my in the right direction, it would be greatly appreciated.
thanks
-Jacob
#3
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
The Megasquirt can be configured internally in any way the builder wants. Pin 2 is one of the spare pins, and can easily be jumpered to ground. Pin 7 is one of the stock grounds, which can also be used.
You'll have to check how the unit is jumpered inside.
You'll have to check how the unit is jumpered inside.
Thread
Thread Starter
Forum
Replies
Last Post