SO heres the problem its weird. So what happens the car will start n idle. If i start to move the car it will dye. Then it wont start agian. Ill move the ms like grab it an move it. its just sitting on the floor right now. The car will start agian. an i can drive it all over. But If i grab the ms well the car is running an move it it dies or turn it over like upside down it dies. I went threw all my wires an there all soldered an tight.

Also i soldered a new db37 in an the same thing. The male part of the ms i even opened up the tips of the pins so that it would make a tighter connection in to the female connecter. Still the same thing. I dont know what it could be i hope this makes sence ill post a datalog tomorrow

 

Sounds like you have a bad connection on the board itself. Cold solder, cracked trace, etc.

 

Humm ill have to check it out now. Im going out side to play with her so ill let u know,

 

ok so i went threw the board tapped everything with the iron. Put it back in an it seems to have worked. I grabbed the box moved it shook it moves wires around so far still good stayed running. Im hoping this was it knock on wood thanks aaron u the man.

 

so far so good. Drove it all night long started up everytime. Pretty sure i got it thanks again aaron.(knocking on wood) lol