Megasquirt MS and Autometer IAT gauge
Thread Starter
Newbie
Joined: Apr 2008
Posts: 3
Likes: 0
From: OH
MS and Autometer IAT gauge
anybody here try to share the GM IAT sensor autput with a single channel Autometer gauge in place of the included thermocouple? Trying to figure out if this is possible.
MegaSquirt Mod
Joined: Sep 2004
Posts: 4,721
Likes: 1
From: Maryland
You will have to take out the IAT bias resistor in the MS, and figure out what the autometer gauge's bias resistor is, then set up the MS for that bias resistor.
It's the same if you share the IAT sensor with the ECU.
Ken
It's the same if you share the IAT sensor with the ECU.
Ken
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
Sep 11, 2015 03:29 PM
