So I am on the latter steps of the megamanal for my MS2. I assembled the jimstim last night and it tested ok using their jumper wire led test.

When I connect it to the MS I do not get any gauge movement on any sensors other then the MAP and whatever else is not controlled by the stim. I have tested the different POTS with the MS connected and without and with different jumper configurations though from what I read that should not impact all of them?

I have to admit I had a lot of issues with the jumper post installation and was surprised the board tested out ok.

I figured I would ask before I just order another stim. Thanks.

 

So the Jimstim is not working for sure. I happen to live down the street from diyautotune (wish I knew that bf I ordered last week..). I drove over today and picked up the regular megastim pre-assembled. Hooked it up and all is well in Tunerstudio.

Kinda wish I had just went that route the first time now. I have a jimstim board with a broken ECU (don't ask) that is assembled (though may not work) if anyone wants it. I will mail it to you for free if you PM your address. Hate to just let it sit here and I will not use it.

 

pm'd