Ok so i just built a 2.2 for my car cause my old one seem to have failed or something. But anyway i followed everything an made sure i put all the cpu chips with the notches to the right location all the resistors to the right side labeled caps with the positive. I got it all done went out to the car an hooked it up two leds lite up an one closest to the db9 was off. I went into the upload firm ware selected the right com port jumped the boot unplugged coils. Clicked a button to go to the upgrade insted of loading the lines it just said failed to load. did i miss something or am i suppost to make a hyperlink an do that stuff. please help me out.

also when i tryed to opening megasquirt an it opened up to the extra uploaded my old log. an all three leds turned on but no spark. I have a zeal daughter board.

 

ok so i finally got it to load up the lines an make it up to 1750+ but now when its done loading those it tells me that the controller has 0.00 voltage. but the leds are on