Megasquirt Firmware failed
#1
Retard
Thread Starter
iTrader: (3)
Join Date: Apr 2007
Location: Denver
Posts: 461
Likes: 0
Received 0 Likes
on
0 Posts
Firmware failed
Ok so i just built a 2.2 for my car cause my old one seem to have failed or something. But anyway i followed everything an made sure i put all the cpu chips with the notches to the right location all the resistors to the right side labeled caps with the positive. I got it all done went out to the car an hooked it up two leds lite up an one closest to the db9 was off. I went into the upload firm ware selected the right com port jumped the boot unplugged coils. Clicked a button to go to the upgrade insted of loading the lines it just said failed to load. did i miss something or am i suppost to make a hyperlink an do that stuff. please help me out.
also when i tryed to opening megasquirt an it opened up to the extra uploaded my old log. an all three leds turned on but no spark. I have a zeal daughter board.
also when i tryed to opening megasquirt an it opened up to the extra uploaded my old log. an all three leds turned on but no spark. I have a zeal daughter board.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM