I'll have to see if I have time to come look at it.

Ken

 

K thanks Ken

 

i definitely feel your pain on this.

 

I may have some time this Saturday.

Ken

 

K. Im not doin anything. Ill double check everything this week. just to make sure that its nothing simple.

 

Any update. If not its all good.

 

I was waiting for you to let me know what time, etc... I can probably make Thursday night assuming the wife keeps her plans the way they are.

Ken

 

Dam. I was waiting for you to say you had time. Lill bit of mis communication. I can do thursday. Im off 216 now so im not too far.

 

OK, I should still have time.

Ken

 

Ill be home at around 4 or 430. So anytime after that is good for me. Ill get everything together that i think i may need.

 

I'll probably get off work around 6. I'll head there from work. PM me an address.

Ken

 

Thanks again Ken. Here is the link that RXDad posted that i mentioned http://stuff.pw.cx/Megasquirt%20MS2%...azda%20CAS.pdf

 

I sent Diyautotune a email but never got a response back

 

What address?

Ken

 

I got one back. I sent another email. I may have misspelled my email. lol. I ordered new q22

 

OK. Glad they're taking care of you.

Ken

 

DIY said there is a resistor between the input and ground on the 2nd VR and that its 347 ohms.

 

Umm... ok?

What's the point?

Ken

 

When we where testing the board thats the resistance that we found at the second VR input. The LM was good and there isnt anything wrong with the board.

 

Yeah, I switched out the board if you remember because I wasn't getting any signal from it. There was something *else* wrong with the board.

In any case, did you figure out your coil issue?

Ken

 

Not yet. Im thinking it may be the ignitor. Not sure though. I took my DVOM and set it up to read resistance and tested the output of D14. And i saw a change from OL to a resistance when i spun the CAS. But im not sure if that means anything anyway. When i ground out the ignitor input the coil did not fire. But then I kinda recalled something about the FC coil needing a square wave or something. Just havnt had the time to research anything ATM.

 

Ken, Im thinking the ignitor is dead. Is there a way i can use a GM 7 prong ignitor the way its setup now? if not Ill see if i can mod the trailing coil to fire at the same time.

 

I wouldn't use the GM ignitor...

I can check around and see if anyone has any 2nd gen leading coils they are willing to sell.

Ken

 

That would be sweet. Ill see if I can find anything also