Megasquirt calibrating coolant and iat sensors

Reply Subscribe

Thread Tools

Search this Thread

Jun 18, 2012 | 02:09 AM

TurboIILover

Thread Starter

Senior Member

iTrader: (2)

Joined: Sep 2007

Posts: 326

Likes: 0

From: El Monte

calibrating coolant and iat sensors

is it possible to calibrate the coolant/iat resistance numbers on a ms1? i know its possible with ms2 and ms3 through tools but is there a way to do the same on ms1 perhaps a back door way, thank you

Jun 20, 2012 | 08:20 PM

TurboIILover

Thread Starter

Senior Member

iTrader: (2)

Joined: Sep 2007

Posts: 326

Likes: 0

From: El Monte

nobody?

Jun 21, 2012 | 01:09 AM

.::evil inside::.

Senior Member

Joined: Jun 2004

Posts: 263

Likes: 2

From: Australia

You just use Easytherm don't you?

Jun 21, 2012 | 12:13 PM

muythaibxr

MegaSquirt Mod

Joined: Sep 2004

Posts: 4,721

Likes: 1

From: Maryland

Yeah, easytherm is the only way to do this on ms1.

Ken

Jun 21, 2012 | 06:25 PM

Jarods7920

Junior Member

Joined: Jun 2012

Posts: 14

Likes: 0

From: Columbia MO

Ya easytherm, or you can get into the INI file and mod it too.

Jun 22, 2012 | 08:56 AM

Aaron Cake

Engine, Not Motor

iTrader: (1)

Joined: Feb 2001

Posts: 29,798

Likes: 128

From: London, Ontario, Canada

Easier just to use the GM temp sensors. They are brand new, widely supported in the industry and don't require code changes to the ECU and Megatune to run. Because remember, if you change firmware for any reason you will always have to use EasyTherm to do it...