GB: FD3S Carbon Fiber Interior
#327
Full Member
iTrader: (2)
Join Date: Apr 2001
Location: Rochester Hills, MI
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone installed there stuff yet? Just had a couple ?'s. Did you reuse the stock screws or get something smaller, the holes don't seem to be drilled big enough for the stock ones? What did you use to keep the turn signals green, the stock plastic pieces are not easily switch over? What I'm most concerned with is the gauge hood though, it doesn't seem to be even close to fitting. The cluster surround is fine because the stock hood fits perfect. I think I would have to tweak it enough that I am afraid of breaking it. Everything looks good, so far I have found 1 screw hole that was not drilled, and my passenger door handle has a good scratch in it, just wanted to figure out the gauge hood so I can address it all at once with JKL. Wasn't even planning on installing before spring, but the gauge hood didn't look right so I started pulling stuff out to check.
#330
sorry it took so long. Finally finished installing the kit today, took a lot of modification to fit. the weave quality is great. as for fitment extremly poor the cluster and the pass door had to be the worst of all had to cut and make custom mount for the gauges to fit. as for flushness pretty bad had to sand down some of the pieces to make it sit flush. keep in mind I didnt work on it everyday, only when I had some free time. but looks great, at least I think so.
#338
1.5 Goodfella's Tall
iTrader: (97)
unless kevin makes some major improvements and start to communicate, I wouldnt recommend it.
#341
Rotor or no motor
iTrader: (24)
next group buy? is this even done? Im still waiting for the rhd pieces...i have been asking JKL to built the interior pieces way before this group buy. We have to go through the european distributor (EVEN IF IM IN THE US)
Thread
Thread Starter
Forum
Replies
Last Post