New Owner and New Member
Thread Starter
Can Post Only in New Member Section
Joined: Mar 2014
Posts: 2
Likes: 0
From: Goose Creek, SC
New Owner and New Member
Hi.I'm Gary.
Recently bought a 1984 Mazda RX-7 GSL-SE. Has the 13B. The body has 65k miles on it and the engine was rebuilt before I bought it and has 3k on it. Interior is spotless. Exterior needs some paint and the windshield has a couple scratches. Also about me; I'm 20 and live in Goose Creek, SC and am in power school right now at NNPTC. Previously I was into car audio and was active on forums. I've never known much about engines especially a rotary. I hope I can learn plenty from you guys and this forum.
Recently bought a 1984 Mazda RX-7 GSL-SE. Has the 13B. The body has 65k miles on it and the engine was rebuilt before I bought it and has 3k on it. Interior is spotless. Exterior needs some paint and the windshield has a couple scratches. Also about me; I'm 20 and live in Goose Creek, SC and am in power school right now at NNPTC. Previously I was into car audio and was active on forums. I've never known much about engines especially a rotary. I hope I can learn plenty from you guys and this forum.
Last edited by misterstyx69; Mar 2, 2014 at 06:41 PM.
Thread Starter
Can Post Only in New Member Section
Joined: Mar 2014
Posts: 2
Likes: 0
From: Goose Creek, SC
Thanks man. Had to replace the starter and put a new radiator in. And the water pump housing gasket blew after I replaced those but when I went to take it off the nuts holding it on were barely torqued past fingertight. Other then that no problems
Thread
Thread Starter
Forum
Replies
Last Post
AXA
Single Turbo RX-7's
8
Sep 5, 2015 10:06 AM