Hay I'm Phil I'm from little old NZ!!!!! , Iv got a series1 rx7 , I have had it for ten years now
White with black interior , has 12a full cut bridge port . 48 Ida alloys just the normal
stuff, has the factory rear end I'd like to up grade it to s3 lsd and disc but have a few questions about getting the brakes to bias properly etc but il bring that up later
( this site seems awesome !!)

 

Hey Phil! Is your car running? or are you trying to figure it how to put together? I'm new too, this site looks awesome.

 

the setup has been running for prob 4 years just pulled it down to paint again and wanting to put back together a lil better !!!!

 

hi phil!

 

Hello Phil.

 

Hello phil. Welcome

 

got my car back from the painter , paint good cars not , come back seized !!!! welder looks to have arc'd through engine, this has resulted in melted stat gear bearings, !!! has any ! ever
struck this , man I was bent about it !!! engine had ownly done 2500 ks very disappointing
so has anyone got good info on rebuilding these 12a engines end float etc , Im a small engine mech by trade and thinking I may have a crack at sorting as to keep cost down

 

this post prob in wrong section but was replying to the Q is my car going, well it was but now it's screwed!!!

 

Hi ! Welcome aboard !