I was trying to run a 0-guage power cable in my FD... it's from battery to rear through driver side firewall...

but, I can't seem to find any pre-drill holes.. but, I am quite sure there's one... and I really don't like to drill a hole that big in my car..

so, does anyone know how can I run my power cable without drilling any hole??
or how do you guys run your power wire

any tips will be greatly appreciated...

thank you

 

there is a huge hole on the driver's side of teh firewall. it's a circular hole that you can only see if you stick your head under the dash and look up and to the left all the way up there. the hole leads through to the engine bay through a large rubber lined rectangular looking hole right in the corner of the engine bay. The hole is perpendicular to the firewall and you have to remove a few screws and some thing in the corner to remove it which is no big deal. Just poke around a bit and try to find it. You have to peel back some of the fender well to funnel the wire through too. It's better than drilling another hole in the firewall though.

 

ya thanks... I got it...

it's quite a big hole... I can probably run 2 or 3 0-guage wires through there.


thanks