Need help with install of Pioneer DEHP-7400mp with Scosche Harness into 1st gen
#1
Need help with install of Pioneer DEHP-7400mp with Scosche Harness into 1st gen
This is a link to the thread in the 1st gen section. If you have any suggestions PLEASE post them! Thank you!
https://www.rx7club.com/forum/showth...hreadid=158096
https://www.rx7club.com/forum/showth...hreadid=158096
#2
Whaz your problem pal?
Just the antenna turn on thing or doesn't the Pioneer work at all?
The upto89-Mazda power antennas are ground switched (like hands free units). So you need a relay that is turned on by the +12V of the Pioneer antenna signal and thats switches the Mazda antenna wiring to ground.
Maybe that's the reason why your Pioneer doesn't work at all. Could have been a short circuit when connecting the antenna remote to the Mazda wiring. I do hope only a fuse inside the Pioneer went up.
See here for the pre89 wiring.
Use an online translator if you do not understand the pinout.
http://www.tobias-albert.de/ta_autoh...azda_1983.html
rgds
Tobias
Just the antenna turn on thing or doesn't the Pioneer work at all?
The upto89-Mazda power antennas are ground switched (like hands free units). So you need a relay that is turned on by the +12V of the Pioneer antenna signal and thats switches the Mazda antenna wiring to ground.
Maybe that's the reason why your Pioneer doesn't work at all. Could have been a short circuit when connecting the antenna remote to the Mazda wiring. I do hope only a fuse inside the Pioneer went up.
See here for the pre89 wiring.
Use an online translator if you do not understand the pinout.
http://www.tobias-albert.de/ta_autoh...azda_1983.html
rgds
Tobias
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
craaaazzy
Comments and Suggestions Archive
3
08-21-15 02:00 PM