showoff

I searched and found a thread or two about the shark-mouth mod for the front bumper of the fd, but does any1 have a link or website that i could goto to actually purchase the kit?

Sprockett

Shark mouth? o_O

Tim Benton

iTrader: (1)

I had picture of my car beside a fellow Atlanta RX-7 owner who had it, but can't find it right now. Bascally it 2 aluminum braces that a a little bit larger than the opening. It pushes the lower lip area down some, opening it up a little more. Not sure how it bolts in since I didn't take a close look at it when I had the chance.

Tim

showoff

yea i understand everything about the kit, and i remeber n-tech used to sell it, but iam having a hard time finding it now"bump"

travisorus rex

http://mahjik.homestead.com/files/FD...0040911_04.jpg

*stolen pic*

Mitch529

go here ---> http://www.ntechengineering.com/inde...d=8&model_id=2

Mitch

Sprockett

Ahh...I thought it was something like the Miata teeth...that doesn't look too hard to custom fabricate - almost like a few bolts, washers, and nuts would do the trick

Mahjik

iTrader: (1)

Sure you can fabricate it, but it's cheap. May as well pay the person who did the R&D (also there is more to the mod than just the two metal pieces, there is cutting of the undercarriage which is in the instructions).

TurboLumpy

wish they had a little more info and pics on the site... but for $40 it looks like a sweet mod

CCarlisi

I have a new one sitting here in an envelope if anybody wants it for $40 shipped.

gfelber

No offense to Nick (N-Tech), but you can achieve the same results by pinning/bolting down the lower portion of the rad inlet and removing the air guide (black plastic thingy). That is, you don't need the vertical supports.

The only decent picture I have is here:

I saw a 10 degree reduction in coolant temps at the track with this mod and a 99 spec front lip!


Gene

showoff

thanx for all the links