Hi,
I need help in replacing a 93 RX7 brake light bulb.

 

I'm sorry for asking this, but are you kidding?
if not--
lift the rear hatch, each taillight is held in by 3 screws which are visible.
Unscrew then slide the taillight away from the car (that goes for the right and left)should pop very easily. (careful cause you need to give it alittle elbow but be prepared cause it does pop right out)
Look on the underside and there are your 3 bulbs.
Did you just get your 3rd gen cause if your having a problem with something this simple your in for a trip with the rest of the car.......
good luck

 

Hey I was stumped when I first got my FD too, I have had many cars and worked on many more from lights to engine conversions, if you think about it, most cars (in my experience) bolt from the back or screw from the front and for the lights to unscrew from the top then slide out from the side was something I had never seen before, I spent half an hour trying to figure it out and the mechanic at the shop i was at did the same before I went and looked in the manual. Im not stupid by any means, but this one got me good!!!

 

Didn't say you were stupid....besides I provided the step by step just in case you were new to the FD.....calm its all good