Interior / Exterior / Audio Talk about interior and exterior mods including audio.

AUdio problems

Old Jan 10, 2002 | 11:20 AM
  #1  
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Nov 2001
Posts: 280
Likes: 0
From: Eugene, Oregon
Question AUdio problems

Doesn't seem to be a fuse blown but once i got my new deck in, it turned off with the dome lights door lights and rear hatch. Can't figure out what it is.
Reply
Old Jan 10, 2002 | 12:23 PM
  #2  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
Dan,

YOU BLEW THE DOME (sometimes also called ROOM) FUSE.

REPLACE THE 7.5 AMP FUSE.

Last edited by Icemark; Jan 10, 2002 at 12:27 PM.
Reply
Old Jan 10, 2002 | 12:33 PM
  #3  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
Again you need to check you are not drawing too much for the new radio. Unless you had the factory accoustic EQ system, there is only a 7.5 amp fuse.

Most aftermarket high power radios draw more than that. 10 amps is typical.

Now if you had the factory accoustic EQ system then there is a 25 amp fuse.

If you are blowing the 25 amp fuse you need to fix your wiring of the radio, you did something wrong.
Reply
Old Jan 10, 2002 | 04:20 PM
  #4  
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Nov 2001
Posts: 280
Likes: 0
From: Eugene, Oregon
Thumbs up

fixed the problem, bad terminal not bad fuse, thanks though
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 06:24 AM.