Interior / Exterior / Audio Talk about interior and exterior mods including audio.

AUdio problems

Thread Tools
 
Search this Thread
 
Old 01-10-02, 11:20 AM
  #1  
Senior Member

Thread Starter
 
Join Date: Nov 2001
Location: Eugene, Oregon
Posts: 280
Likes: 0
Received 0 Likes on 0 Posts
Question AUdio problems

Doesn't seem to be a fuse blown but once i got my new deck in, it turned off with the dome lights door lights and rear hatch. Can't figure out what it is.
Old 01-10-02, 12:23 PM
  #2  
Former Moderator. RIP Icemark.
 
Icemark's Avatar
 
Join Date: Apr 2001
Location: Rohnert Park CA
Posts: 25,896
Likes: 0
Received 19 Likes on 19 Posts
Dan,

YOU BLEW THE DOME (sometimes also called ROOM) FUSE.

REPLACE THE 7.5 AMP FUSE.

Last edited by Icemark; 01-10-02 at 12:27 PM.
Old 01-10-02, 12:33 PM
  #3  
Former Moderator. RIP Icemark.
 
Icemark's Avatar
 
Join Date: Apr 2001
Location: Rohnert Park CA
Posts: 25,896
Likes: 0
Received 19 Likes on 19 Posts
Again you need to check you are not drawing too much for the new radio. Unless you had the factory accoustic EQ system, there is only a 7.5 amp fuse.

Most aftermarket high power radios draw more than that. 10 amps is typical.

Now if you had the factory accoustic EQ system then there is a 25 amp fuse.

If you are blowing the 25 amp fuse you need to fix your wiring of the radio, you did something wrong.
Old 01-10-02, 04:20 PM
  #4  
Senior Member

Thread Starter
 
Join Date: Nov 2001
Location: Eugene, Oregon
Posts: 280
Likes: 0
Received 0 Likes on 0 Posts
Thumbs up

fixed the problem, bad terminal not bad fuse, thanks though
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
The1Sun
New Member RX-7 Technical
5
09-15-15 04:45 PM



Quick Reply: AUdio problems



All times are GMT -5. The time now is 09:32 PM.