1994 FD RX7 Fender Rolling & Wheel Fitment
#26
FD + 2JZGTE = WIN! **D
iTrader: (19)
I'm pulled and rolled on OEM fenders.
I've ran 18x9.5 +38's with 275/35/18 Toyo R888's that only barely scrubbed the fender liner every now and then. Could still turn 100%.
I currently run 19x10 +25 and 19x11 +25 Volk RE-30's with 235/35 and 275/35 tires. Doesn't really scrub at all. Can turn 100%.
I've ran 18x9.5 +38's with 275/35/18 Toyo R888's that only barely scrubbed the fender liner every now and then. Could still turn 100%.
I currently run 19x10 +25 and 19x11 +25 Volk RE-30's with 235/35 and 275/35 tires. Doesn't really scrub at all. Can turn 100%.
Last edited by YoshiFD3S; 12-26-17 at 08:12 AM.
#27
Junior Member
18x10 ET22 FRONT will need to be rolled, cambered, and stretched but would highly recommend using a higher offset...
18x11 ET16 REAR will need a severe pull even with a stretched tire and camber I don't see this fitting...
I helped a guy out yesterday on the forum with pictures of my current setup that may help you out in determining what you'd like to run.
Current setup:
18x9.5 ET38 255/35 FRONT
18x9.5 ET15 275/35 REAR
Fronts fit no problem and could even be fine up to about an ET30. Rear needed a pretty substantial roll to be cleared and I believe 275/35 in a 9.5 wheel with ET15 is about as far as you can go. I don't see an 11" wheel ET16 fitting without a flare...
Before rolling fenders fitment below. Running 0 degrees of camber in REAR and less than .5 degree in FRONT.
Hope this helps out
18x11 ET16 REAR will need a severe pull even with a stretched tire and camber I don't see this fitting...
I helped a guy out yesterday on the forum with pictures of my current setup that may help you out in determining what you'd like to run.
Current setup:
18x9.5 ET38 255/35 FRONT
18x9.5 ET15 275/35 REAR
Fronts fit no problem and could even be fine up to about an ET30. Rear needed a pretty substantial roll to be cleared and I believe 275/35 in a 9.5 wheel with ET15 is about as far as you can go. I don't see an 11" wheel ET16 fitting without a flare...
Before rolling fenders fitment below. Running 0 degrees of camber in REAR and less than .5 degree in FRONT.
Hope this helps out
#28
Full Member
Where did you get these lugnuts, and does anyone here have an extended stud (say by 8-10mm) they recommend?
Cheers!