I am continuing to have problems with me innovate hooked to my Haltech. The gauge and the Haltech were reading the same a/f at first. I put the car on the dyno and now no matter what load the engine is at or even if it is running or not it oscillates between 10.04-10.35 on the datalog and in the analog input page.

I am running 1.89.


Is it the innovate or the Haltech? How can i figure it out?

 

Check the output voltage of the Innovate. If that jives with what the Haltech is reading it's the LC-1. Do you have the LC-1 hooked to a gauge or just the Haltech?

 

Did you calibrate the Haltech to accept the default output signal from the innovate? The calibration in the Haltech software is set to something like from 10AFR = 0V and 20AFR= 5v, but the default that the LC-1 comes with is more like 7.35AFR=0v and 22.39AFR=5v, so you have to match them properly.

Apart from that, have you configured everything correctly?