Haltech Start up problem after engine swap.
ok after reading a lot, did you check if the injectors are not stuck open? I read that you need to make sure the gaskets are all there in the primary, and make sure the o rings are not pinched. I will double check this when it stops snowing
Thread Starter
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
We got smoke!..
Success..I think!
I looked at some maps and compared to mine it seemed that the Trigger setting was Incorrectly set.(needed to be set to RX 8 )
HOW did it change?.dunno?..it ran fine the last time an engine was In the car..lol!
anyways.I put a Map in..WHHRRR..BOOOM!...STARTED UP!
ran it 15 seconds and LOST The Car in the smoke!..
Cough..so much for trying to quit smoking!
I looked at some maps and compared to mine it seemed that the Trigger setting was Incorrectly set.(needed to be set to RX 8 )
HOW did it change?.dunno?..it ran fine the last time an engine was In the car..lol!
anyways.I put a Map in..WHHRRR..BOOOM!...STARTED UP!
ran it 15 seconds and LOST The Car in the smoke!..
Cough..so much for trying to quit smoking!
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM