I use the pwm 4 output as a switch for the relay controling the solenoid my water injection sys. It is set to Water in jecttion on the E8 for that output, and it works well. I know it is working because I have a led hooked up to the power wires of the relay so I see when its on. However, I cant seem to be able to log the status(of/on) of that output.
I have selected the folowing parimiters to log but they all come up as 0.

PWM 4 duty
PWM 4 frequency
Aux 4 out digital

Is there another way?

 

It's a digital out when setup as water injection. Duty and frequency will not change because it is a digital out. Digital state should change from 0 (off) to 1(on).

 

Thanks for the info C. Ludwig I will try again.