Haltech New Haltech-er!.and need a Start up map.(tips?)

Reply Subscribe

Thread Tools

Search this Thread

Aug 15, 2011 | 07:15 PM

misterstyx69

Thread Starter

Retired Moderator, RIP

iTrader: (142)

Joined: Sep 2005

Posts: 25,581

Likes: 136

From: Smiths Falls.(near Ottawa!.Mapquest IT!)

New Haltech-er!.and need a Start up map.(tips?)

Ok,I am trying to get the old Beast up and running before I grow old!(quick!!.I am there!)
I have the Platinum 1000 with a TII engine.Prewired harness and a FFE crank trigger.
750 pri/1000 sec.BNR stage 3 Turbo and 3 inch RB exhaust.
Wiring:can I use the old Fuel pump Fuse Slot for 12v Switched?
I am going to run the Fuse block(haltech) directly to Battery.
Thanks Guys,car has been down 2 months and I would like to drive it before SNOW!.Summer has been a Fiasco.

Aug 16, 2011 | 12:54 AM

C. Ludwig

www.lms-efi.com

iTrader: (27)

Joined: Mar 2001

Posts: 5,265

Likes: 146

From: Floyds Knobs. IN

You have an email.

Use the switched input from the stock ECU connector as your switched source for the Haltech.

Aug 16, 2011 | 11:17 PM

misterstyx69

Thread Starter

Retired Moderator, RIP

iTrader: (142)

Joined: Sep 2005

Posts: 25,581

Likes: 136

From: Smiths Falls.(near Ottawa!.Mapquest IT!)

I got the email.Thanks Chris.( you da man!)
Now,How can I open files to look at them?,(seriously,my Laptop doesn't open them,I know it's my Fault!)
..you say the Switch wire for the ECU: On what harness plug?.Color of wire would be fantastic!

Aug 17, 2011 | 12:40 AM

C. Ludwig

www.lms-efi.com

iTrader: (27)

Joined: Mar 2001

Posts: 5,265

Likes: 146

From: Floyds Knobs. IN

You need the ECU Manager software to view the map files. It's on the disk that was included in your kit.

The stock ECU connectors in the passenger footwell. Not sure which wire color off the top of my head. Use a test light to see which wire has positive voltage in the run AND start position. That is your wire.