Haltech New Haltech-er!.and need a Start up map.(tips?)
#1
Retired Moderator, RIP
Thread Starter
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
New Haltech-er!.and need a Start up map.(tips?)
Ok,I am trying to get the old Beast up and running before I grow old!(quick!!.I am there!)
I have the Platinum 1000 with a TII engine.Prewired harness and a FFE crank trigger.
750 pri/1000 sec.BNR stage 3 Turbo and 3 inch RB exhaust.
Wiring:can I use the old Fuel pump Fuse Slot for 12v Switched?
I am going to run the Fuse block(haltech) directly to Battery.
Thanks Guys,car has been down 2 months and I would like to drive it before SNOW!.Summer has been a Fiasco.
I have the Platinum 1000 with a TII engine.Prewired harness and a FFE crank trigger.
750 pri/1000 sec.BNR stage 3 Turbo and 3 inch RB exhaust.
Wiring:can I use the old Fuel pump Fuse Slot for 12v Switched?
I am going to run the Fuse block(haltech) directly to Battery.
Thanks Guys,car has been down 2 months and I would like to drive it before SNOW!.Summer has been a Fiasco.
#3
Retired Moderator, RIP
Thread Starter
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I got the email.Thanks Chris.( you da man!)
Now,How can I open files to look at them?,(seriously,my Laptop doesn't open them,I know it's my Fault!)
..you say the Switch wire for the ECU: On what harness plug?.Color of wire would be fantastic!
Now,How can I open files to look at them?,(seriously,my Laptop doesn't open them,I know it's my Fault!)
..you say the Switch wire for the ECU: On what harness plug?.Color of wire would be fantastic!
#4
www.lms-efi.com
iTrader: (27)
You need the ECU Manager software to view the map files. It's on the disk that was included in your kit.
The stock ECU connectors in the passenger footwell. Not sure which wire color off the top of my head. Use a test light to see which wire has positive voltage in the run AND start position. That is your wire.
The stock ECU connectors in the passenger footwell. Not sure which wire color off the top of my head. Use a test light to see which wire has positive voltage in the run AND start position. That is your wire.
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM