Is there a good way to log AFR values in ECU manager like you can in Datalogic, E-manage Ultimate etc? To log the AFR values in each load point.

 

No. People have been asking for it. Hopefully it will be a future development.

 

Thats to bad, so only way to log is to do it verses time?

 

It's easy enough to reference a load/rpm junction versus a/f ratio in the logs so that you know where you need to make changes. This method works just as well, probably just not as intuitive as map watch.

 

Trace feature should also help you with that, during a run hit "T" for trace and ECU Manager will draw a line where the cursor has been, after the run hit the "T" again to stop the trace and view where you were, if you dont hit "T" the line will keep tracing and recycle. Hit it a 3rd time to remove the line from the table.

 

The trace helps but it really is not a sustitute for a map watch function.

Claudio do you know if they are working on a map watch function? If not I may start working with the guy I had before to create a separate program to do this. Its just easier when the ecu software would do it as it knows the cell ranges requiring no setup. The program worked for the older software but when the platinums came out the CVS files changed logging format.

 

Thanks for your replies! In a dyno I think the trace function is good enough but since I do a lot of low-and middle-load on the public roads the maptrace is a tool I realy miss.