hello all. installing an innovate LC-1 wideband and it has two options for outputs.

The default analog outputs are as follows: Analog output one is 1.1V = 14 AFR and .1V = 15 AFR, and Analog output two is setup as 0V = 7.35 AFR and 5V = 22.39
AFR.

which output should i tie into the haltech?im assuming the 'Analog output two" is correct. is there a setting i have to change so it will read the wideband correctly or is the stock wideband voltage range correct?

thanks for your input.

 

Use output two. Easiest to leave the Innovate output calibration alone (though it can be changed) and just change the Haltech input to match. Enter the values above in the wideband input calibration in the Haltech software and you're on your way.

 

awesome thanks!