Haltech S6-8 Crank Angle Harness Question (HT-130334)
#1
Haltech S6-8 Crank Angle Harness Question (HT-130334)
The CAS connectors on the Haltech CAS sub-harness are the same color. They're not white and grey like the stock harness. The Haltech instructions label their connectors as "home" and "trigger"? Which one corresponds to the white and grey connectors?
#2
Senior Member
The HOME connector goes on the sensor that picks up the Single tooth signal and that sensor is the closest to the driver side. The TRIGGER reads the inner 12 teeth and the sensor should be closer to the crank, timing needle, and the passenger side. This is if you're on the OEM crank disk of course.
Thread
Thread Starter
Forum
Replies
Last Post