With the assistance of Kathleen G. at Tyco, I've found the Haltech Platinum Sport 1k/2k's connectors. They're Super Seal 1.0mm with Key ID 1. So in case you want to make a custom harness or the ECU connectors get damaged for some reason, we can NOW replace them with the original parts. Can someone say Patch Harness?

Here's the Harness's connectors
26-pin connector: 2-1437285-2
http://www.tycoelectronics.com/catal...PN=2-1437285-2

34-pin connector: 4-1437290-0
http://www.tycoelectronics.com/catal...PN=4-1437290-0

These are the pins for the connectors
For 18-16-gauge wire: 3-1447221-3
http://www.tycoelectronics.com/catal...39,489335&N=11

For 20 Gauge Wire: 3-1447221-4
http://www.tycoelectronics.com/catal...556,517306&N=2

Here's the connectors on the ECU itself:
34-pin: 6437288-1
http://www.tycoelectronics.com/catal...556,517306&N=2

26-pin: 6437288-6
http://www.tycoelectronics.com/catal...556,517306&N=6

I'm sure all the guys without garages will really appreciate this info, in order to make an indoor "boot harness" to load maps inside.

 

Good info. However, good luck finding them at a vendor who is willing to sell them in single units. Though Tyco/AMP will ship "samples" to anyone free of charge.

 

They do sell those in singles btw. We normally get ours from Motec as a kit but they're a bit more expensive.