i downloaded a new map for my haltech e6k ecu with all the mods i have and i put it in and went to start the car and the tac reads 1-1200 rpms and wont start. white smoke is coming out the tail pipe i can smell gas. i need to know what is going on

 

help

 

sounds like its flooded. not enough info to go further, what was wrong with your old map?

 

it seemed to run a little lean so i downloaded a new one but my dumb *** didnt save the old map. so i downloaded the one closest to my set up and the car wont start. the idle goes up to 1100 when i try to turn it over the haltech reads it so i dont understand i have fuel and spark but no fireing???

 

Columbus, OH, IN or GA? I can get you sorted out if it's either of the first two.

 

columbus ohio

 

Email me and I'll give you a hand. I'm about 3 hours South of you and originally from Tiffin, OH. I make it up that way quite a bit as well.

ludwigmotorsports@insightbb.com

 

email sent

 

emailed list of mods still waiting for reply

 

I looked at the map you have and the setup looks right for an FD. That is what you have? If that is correct then you just need someone that knows how to trim the fuel to get you up and running.

 

yes its a fd but what i dont understand is that the rpm reads 1000+ when i turn the key. i borrowed a power fc and it started right up. im getting a power fc and selling the haltech

 

yes its a fd but what i dont understand is that the rpm reads 1000+ when i turn the key. i borrowed a power fc and it started right up. im getting a power fc and selling the haltech