I saw this

https://www.rx7club.com/showthread.p...ght=Fan+wiring

I wanted to setup my fans on high also. I understand how to make them run on high at the desired setting but i cant figure out where the Violet/White wire goes. It says it goes to the old stock ecu harness which is 3D White/Blue. But the old harrness has been removed replaced by the haltech harness. So where does the violet/white wire go? There are a couple W/L also know as White/blue wire running from a blue connector and there is also a white/blue wiring running frmo a black control box under the kicker panel. So basically where does the Violet/White wire go, what color wire dose it connect to and what the color of the connector! TIA
Marc

 

a PWM will go to the w/l wire in the kickpannel. to make it run on high, you will need to mess with the wiring at the relays. in the link posted, my colors were different, but by comparing where the wires were in 2 diffent cars i was able to figure it out. i forget now. i will look through my nots, but i dont know that i wrote it down.... in other cars i did, just running the PWM to the w/l wire ran the fans on medium, and they have had no problems. in the PWM page in software, i just set them to come on a little sooner...

 

I have a question, i just put a set of flex a lite fans in my FD and looked at the factory plug for the fans found 1 positive and two grounds. anyways i just hooked them up and the fans work. does this mean im not operating the fans at high speed? can they go faster. when i tested it with a voltage meter i was getting 12 volts. and another thing is that when the car is off. there is a realy (1 of the 4) top one to the rear of the car is always a little warm.

let me know what up

thanks
Rob

 

^gonna raise this from 6 ft under.
Incase anyone with a JDM FD is doing this, I had to use the green wire black stripe on the blue connector to get my fans to work.