I'm running a FD UIM on my FC and am using the FD BAC...anyone know how I'm supposed to wire it to my PS1000?

Thanks.

 

20B BAC being same, i have it wired to DP01 output - BAC Main, Closed loop, 380Hz

 

Switched 12V+ to one side and any DPO to the other. DPO 17 and 18 are high current capable injector drivers so I like to use them for boost and idle control, if I'm not using them for injectors. DPO 1 is the only output with a switchable pull-up, so I reserve that for a tach output, just in case. For the switched 12V+, use one of the spare gray/red wires in the flying lead loom.

 

Anyone have the proper settings for it (Freq, etc)?

 

NM, found this thread: https://www.rx7club.com/haltech-foru...-works-957028/

Which has a great amount of info and a good explanation on setting up the duty cycle.

Chris, the Haltech community owes you big time for the amount of support you give us.