Recently setup my brother in laws E6X on his FC anyway the A/D spare input and the O2 wires don't seem to change values. I have a WBO2 running to the A/D and I only get one voltage reading in the software though I can probe different voltages at the connector, so I know its getting voltage. Same thing seems to be happening with the O2 input wire. Anyone have this issue before and how do you go about getting this fixed?

Thanks

 

What do you have the Spare A/D input setup as? If you want it to simply record the voltage you should set it to General.

 

I have tried it as General, 02, and UEGO without the values changing. I am fairly certain its the unit as the voltage going in was always a completely different voltage, than that displayed. Also trying to figure out who to send the unit to to have it checked out as the Haltech website doesn't say much.

 

I assume you're connecting to the red/black wire? Just covering the obvious.

Try saving your map as it is. Then load a completely new map. Then load your current map again. Sometimes the E6X likes to hang on stuff like this and reloading everything gets it going again.

If all else fails contact Haltech USA @ 760-598-1941. Or PM Claudio as he's on staff there now.