Haltech E6s-8 Wiring Diagram?
#2
EFI Tech Wannabe
iTrader: (1)
Join Date: Sep 2003
Location: D.R., USA, the world...
Posts: 2,405
Likes: 0
Received 4 Likes
on
4 Posts
www.haltech.com , download section, the E6S diagram is right there.
Now, the problem with wiring up an E6S onto an FC is the following, depending on what firmware is in the unit you might not be able to read off the stock reluctors inside the CAS. You will need to either get a Haltech reluctor adapter (RA10) or a pair of MSD-8509 boxes, and you will also may not be able to connect it the way the stock FC ignition system works.
What you could use is a set of 4 LS1 coils which will allow you to run wasted spark with good results and not worry about the stock ignition system. Now, the E6S had only so many outputs that all will be taken up when you connect it all, unlike with the E6K/X that had 4xPWM outputs to let you connect other auxiliar options.
Last edited by Claudio RX-7; 10-23-07 at 07:12 PM.
Thread
Thread Starter
Forum
Replies
Last Post
windom
Adaptronic Engine Mgmt - AUS
4
09-11-15 04:48 AM